Charging and Power

Your CyberScope Air includes a USB-C 15V/3A power adapter.

CAUTION! Only the NetAlly-supplied power adapter is supported.

To begin charging the internal lithium-ion battery, plug the included power adapter into an AC outlet and the USB-C charging port on the left side of the tester. The Status LED blinks red when the tester is off and charging and turns solid red at full charge. Refer to the Specifications for battery run duration and charge times.

Powering On

• To start the tester, hold down the Power Button for approximately one second until the Status LED turns green.

• When the display goes into Sleep mode, the Status LED blinks green to indicate the battery level. Tap the Power Button briefly to wake up the display. (Set the timing for display sleep and auto power off in the Device Settings.)

• To shut down or restart, hold down the Power Button for one second until the “Power off” and "Restart" dialog box appears on the touchscreen, and then tap Power off or Restart.

• If the tester is unresponsive to a normal power off, press and hold the Power Button for five seconds to perform a hard shutdown.