The 1Gbps Wired Performance Test is used to ensure that newly installed or upgraded wired networks meet SLA objectives and are ready for new high-bandwidth applications by measuring end-to-end path performance.
Measures:
- Throughput
- Frame Loss
- Latency
- Jitter
The Wired Performance test measure performance at rates of 50kbps and up to 1Gbps on both copper and fiber networks.
Controller (Master):
- OneTouch AT G2
- OneTouch AT 10G
Remote Types (End Point):
- Peer – Provides Bi-directional upstream and downstream results. The only supported device for the OneTouch AT Wi-Fi or wired performance test is another OneTouch AT.
- Reflector – Provides roundtrip results. The OneTouch AT supports the following devices as a reflector for Wi-Fi or wired performance testing:
- LinkRunner Pro or Duo (legacy)
- LinkRunner AT
- LinkRunner G2
- Windows PC (running the reflector software)
Required Ports:
- UDP 3842 Data Test Port
- TCP 3842 Test Setup and Tear Down Port
- UDP Port + 1 for latency Frame Default 3843 (OneTouch AT)
NPT Tests through its Wired or Wi-Fi test port against several types of remote end-points.
* Depends on the availability and performance of the Network Interface of the Windows PC.
NOTE: It is recommended to configure the Remote (End Point) first because you will need the IP of the Remote (End Point) to configure the Controller (Master).
Remote End Point Configuration:
Select configuration options below:
- LinkRunner AT (Reflector)
- LinkRunner G2 (Reflector)
- OneTouch AT G2/10G (Peer)
- Windows PC (Reflector)
OneTouch AT G2/10G Controller Master Configuration:
- From the HOME Screen Tap and Hold to get a list of User Tests.
- Tap 1Gbps Wired Performance (RFC2544)
- Tap Type: Peer and select the option “Peer” for another OneTouch AT or “Reflector” for everything else.
- Enter the IP Address of the Remote (End Point) and Tap Done.
NOTE: The remaining parameters are optional and should be configured based on your performance test requirements. In this example, I will leave them at their DEFAULT values.
- Tap Test again. (if an AutoTest has not already completed, the AutoTest will begin) followed by the 1Gbps Wired Performance Test
